$100.00

Power Feed – Z Axis Knee Lift Kit For Milling Machine

Add to Wishlist
> SKU: N/A
A
  • Brand new Power feed AL-510Z
  • Variable speeds – Torque 650in-lb
  • Z traverse ( Up – Down travel )
  • Available in 220V or 110V ( X Y Z )
  • Effortless operation
  • Noiseless direction changes
  • Better surface smoothness
  • Small volume and easy installation
  • Excellent speed control in the entire range
Add to Wishlist

$689.00 $589.00 Inc tax

Compare

Description

Brand New AL-510s Z – Axis Power Feed Kit is for Bridgeport and Similar Knee Type Milling Machines. These will fit almost any vertical knee type mill out there with the 5/8″ Shaft End, Including but not limited to Bridgeport, Precision Matthews, Grizzly, Enco, Jet, Sharp, Acer, Webb, GMC, Kent, Clark, Supermax, Enco, Turn Pro, Vectrax, Acra, Birmingham, Accu, First…etc. The gear ratio between transmission plastic gear and motor shaft gear is not a whole number. The two gears will not mesh and wear at the same spot, this not only increases durability and longevity but even reduces noise over time.

Speed adjust knob

Speed can be adjust according to operator’s  requirement, ranging from 0-9.

Jog switch

Normally, jog switch should be at “FEED” position. For jog movement, just switch to “0” position. Kept holding the switch until it travels to requires position.

lable

A

Specifications

  • Type: Z traverse
  • Model: AL-510SZ
  • Voltage: 110V, or 220V 50/60Hz
  • Rotate speed: 0-200 RPM
  • Max torque: 650 in-lb
  • Max feed rate: 650mm/min
  • Max return speed: 850mm/min
  • Dimension: 8 x 4.5 x 13 inches
  • Package size: 11.8 x 8.7 x 13.8 inches
  • Gross weight: 16.5 lbs

Feature

  • Brand new power feed
  • Variable speeds
  • Z traverse ( Up – Down travel )
  • Longer lifespan
  • Effortless operation
  • Noiseless direction changes
  • Better surface smoothness
  • Small volume and easy installation
  • Excellent speed control in the entire range
  • Power table feed won’t vibrate or strain in low speed
  • Direction control knob for easy and rapid operation
  • Safety feature to protect transmission gear and electronic components

Package Content

  • 1 x Power Feed For Milling Machine
  • 8 x Adjustable Pad
  • 2 x Tiavel Stop Assembly
  • 1 x Adapter
  • 1 x Bevel Gear
  • 1 x Dial Nut
  • 1 x Locking Nut
  • 1 x Product Manual

Reviews (0)

0.0
0
0
0
0
0

Be the first to review “Power Feed – Z Axis Knee Lift Kit For Milling Machine”

There are no reviews yet.